Home page
8 WRAP COIL SET
$ 20.00
THESE COILS ARE WOUND WITH A PURE MAGNETIC IRON CORE THAT IS SPECIFICALLY MADE FOR ELECTROMAGNETICS. WOUND BY HAND WITH PREMIUM 24ga COPPER WIRE. 8/32 THREADS THESE COME UNSOLDERED.
Ahren Bloomquist Shader
Sold Out
The shaders features 8 wrap hand wound coils, hand cut single piece spring. They will push any needle grouping, do solid color, black and grey or color blending easily and...
Armature Bar - Lightened - Steel - 1.5 (Diamond)
Sold Out
1.500" lightened armature bar, also known as a speed bar. Made from low carbon steel and put through a special heat treat process. Tapped for an 8/32 screw. 3/8" long...
Base Plate - Left-Hand - Drop Down
$ 13.00
Left-handed drop down base plate. This base plate is designed to make a left-handed machine and has a drop tube vise so you can use full-length needle bars when using...
BIG GRIP THROW 'EM AWAY TUBES
$ 15.50
These tubes are gas sterilized and individually sealed in blister packs. The stem and tips are made from rigid ABS plastic so they don't flex and also have a BIG...
Binding Post - Rear - Brass
$ 2.50
This brass rear binding post is based on a Doc King binding post. It is designed to be used either horizontal or vertical. All holes are for 8/32 screws.
Coil Core - Washers
$ 0.15
Coil core washers for 5/16" diameter coil cores available in black, red, or grey fibre material. Black or brown phenolic for 5/16" diameter coil cores. Black fibre material for 3/8"...
Coil Cores - T-Top - Pure Iron
$ 1.70
T-top style coil cores. This PURE IRON material is made specifically for electro magnetic coils and holds zero residual magnetism. Available in 1" and 1.250" *Put through secondary process to...
Contact Screw - Nickel Silver - 8/32
$ 3.50
8/32" threaded nickel silver contact screw. Available in 1" or 1.25" length.
MONO MAMBA CORD FROM PATTON MFG
$ 40.00
These clip cords are hand made by Patton Mfg. They are one sided and the cord is made from a material that is not sticky so it will easily slide...
PERFECTION
$ 3.50
Classic side plate based on the Jensen Perfection frame. Precision water jet cut from 10ga cold roll steel.
REAR UPRIGHT
$ 8.00
Rear upright for building a single upright style machine. Made from 1018 cold roll steel, drilled and tapped 8/32 threads.
SPECIAL
$ 3.50
Classic side plate based on the Jensen Special frame. Precision water jet cut from 10ga cold roll steel.
Spring Shelves
$ 1.40
Our spring shelves are 1/4" thick x 1/2" x 3/4" and tapped for an 8/32 screw. They are made from low carbon steel.
WALKER STYLE SIDE
$ 3.50
Classic side plate based on the Walker style frame. Precision water jet cut from 10ga cold roll steel.
WATERS NO.6
$ 3.50
Classic side plate based on the Waters no. 6 frame. Precision water jet cut from 10ga cold roll steel.